Skip to main content ↑ ↓
Topic: Heater problem (Read 541 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Heater problem

Yahoo Message Number: 15568
2007 gulfstream endura - heater was working earlier today but now it tries to kick on but will not light - is their a reset switch like on a gas hot water heater

The fan runs but won't kick on - sounds like it is trying to light but doesn't - any suggestions - thank you so much

Best,
Steve Phillips

Re: Heater problem

Reply #1 –
Yahoo Message Number: 15570
I had a similar problem with the Atwood furnace in our Seneca. I replaced the ignitor, flame sensor, and sail switch to no avail. I ended up replacing the circuit board with a Dinosaur Electronics equivalent and that did the trick. Haven't had a problem since...

Ty

Re: Heater problem

Reply #2 –
Yahoo Message Number: 15575
When my furnace did that. I removed outside cover. Then took fan cover off. Checked switch on the cover. It was OK. It's called a sail switch. I them got circuit out. It is on left side fan housing. Removed wire connector from board. Used a clean pencil eraser to clean contact. Put everything back together. Furnace worked OK after that.
Best
Ron Hall