Heater problem October 07, 2016, 10:22:23 pm Yahoo Message Number: 155682007 gulfstream endura - heater was working earlier today but now it tries to kick on but will not light - is their a reset switch like on a gas hot water heaterThe fan runs but won't kick on - sounds like it is trying to light but doesn't - any suggestions - thank you so muchBest, Steve Phillips Quote Selected
Re: Heater problem Reply #1 – October 08, 2016, 12:16:57 pm Yahoo Message Number: 15570I had a similar problem with the Atwood furnace in our Seneca. I replaced the ignitor, flame sensor, and sail switch to no avail. I ended up replacing the circuit board with a Dinosaur Electronics equivalent and that did the trick. Haven't had a problem since...Ty Quote Selected
Re: Heater problem Reply #2 – October 08, 2016, 03:12:10 pm Yahoo Message Number: 15575When my furnace did that. I removed outside cover. Then took fan cover off. Checked switch on the cover. It was OK. It's called a sail switch. I them got circuit out. It is on left side fan housing. Removed wire connector from board. Used a clean pencil eraser to clean contact. Put everything back together. Furnace worked OK after that.BestRon Hall Quote Selected